Released: June 2, 2017

Please note: In Windows 10 you may get a driver signing error during installation. If so, please read these instructions to resolve.

Also, that some virus protection programs claim that LynxMixer.exe has a virus, it does not.  The virus scanners are reporting a false positive.

Revision History
Version 2.0 Build 23e  June 2, 2017

  1. Added support for Aurora(n)-TB.

Version 2.0 Build 23d  Janunary 31, 2017

  1. Internal release for testing purposes.

Version 2.0 Build 23c  June 29, 2016

  1. Fixed issue created in Build 23b that caused PCI cards to use WavePCI instead of WaveRT on Windows Vista and higher.
  2. LynxTrayVolume.exe now launches LynxMixer.exe instead of LMixer.exe upon double-click.

Version 2.0 Build 23b  May 27, 2016

  1. Added ability to change channel mode on E22 and E44.  E22 can now do 2 or 4 channel mode.  E44 can now do 2, 4 or 8 channel mode.
  2. Driver now enables record device for DMAV2PLUS firmware if the application did not already enable a record device.  Since newer DMAV2PLUS firmware depend on record device timing, a record device must always be enabled.

Version 2.0 Build 23a  November 30, 2015

  1. Fixed issue with topology driver that would change the wrong controls for the source volumes.
  2. Change the topology driver to always report the number of channels at either 8 or NumberOfWDMDevices * 2 (whichever is less).  This corrects an issue where Windows would always show the number of volume controls for the first device as two instead of the number of channels that are selected in the Windows Sounds Control Panel.
  3. Added work-around for issue with Adobe Audition CC 2014 and up that would cause the ASIO driver to not load properly.
  4. Added work-around for issue with ProTools 11 and up that would cause the ASIO driver to occasionally not load properly on an Aurora™-TB.

Version 2.0 Build 23  August 27, 2015

1.  Added support for DMAV2PLUS for AES16e/LT-TB/E44/E22.
DMAV2PLUS supports the following features:
– 5.1 support for WaveRT (6-channel interleaved)
– Smaller transfer sizes to reduce latency to under 1ms round-trip (96kHz, 32 sample buffer)
DMAV2PLUS is supported with the following firmware:
AES16e: 14.0
LT-TB: 6.0
E44/E22: 2.0

2.  Added new controls in Lynx Mixer to support DMAV2PLUS.  Settings > Advanced > Hardware Buffer Size.  This settings should be left at ‘Auto’ unless you are working with Lynx Technical Support on a specific issue.  Changing this control sets the amount of audio buffered in the hardware.  The smaller the number the faster the CPU must respond to interrupts before audio breaks up.

3.  Added additional check for PCI cards on startup of Lynx Mixer.exe to automatically launch LMixer.exe if no PCI Express devices are detected.

4.  ASIO driver now allows buffer sizes from 32 up to 8192 samples for DMAV2 and DMAV2PLUS devices.  Previously this was set from 32 to 1024.

5.  ASIO driver cannot mix DMAV2 and DMAV2PLUS devices along with standard DMA devices.  All devices must support the same feature set.

6.  Includes Hilo Remote Version 1.0.11.